Upgrading the firmware is relatively easy with the SPA The STUN settings should be optional. There are a lot of settings here that are not strictly necessary for a functional phone, but if you wish the SPA to behave similar to a Telecom landline then you are best changing the settings on this page. The example Dial Plan is an example for New Zealand only and may be incomplete. Please send feedback to support www.
Most of the settings on this page are up to the customer and whether they wish to support call waiting,caller ID etc. Turn on your modem and your computer and wait for them to start up typically, when all lights have turned green.
This will turn the VoIP phone adapter on. Pick up the telephone handset and listen for a dial tone. You can now make calls now! Please check our installation troubleshooter. Configuring you own device. This sounds complicated, but it can be completed in just a few steps.
Links to all these documents can be found from the link below:. Please refer to the User Guide for more info. We will only discuss those that are important to the kiwivoip service in this article. If you wish to experiment with the other settings then please consult the User Guide for more information. The following settings refer to the pages which you can select using the tabs along the top of the page.
If you do not see a setting mentioned then you should leave this as the default setting. If you purchase a second hand SPA or one that has been setup to work with a particular carrier then the safest bet is to reset the settings to the factory defaults so that you start with a clean slate and can be sure that some previously entered setting is not causing you a problem.
0コメント